HDMI and SDI sources Print

  • hdmi, capture, v4l2
  • 0

Medusa Panel › Stream › Add Stream

Medusa ingests over the network and from DVB or SAT>IP tuners; it does not read an HDMI or SDI capture card directly. To bring a baseband HDMI or SDI feed in, put an external encoder in front of the engine that turns the feed into a network stream, then ingest that stream as an IP source.

The chain

  1. Connect the HDMI or SDI feed to a hardware encoder, or to software such as OBS on a capture-equipped machine.
  2. Have it publish a network stream — RTMP-PUSH, SRT or UDP are the usual choices.
  3. In Medusa, add a stream whose Source Stream is that encoder’s URL (or set the engine to listen for the RTMP-PUSH / SRT publish) — see IP sources.

From there the feed behaves like any other source: transcode it, build a ladder, package and deliver it.

Pick the transport for the link: SRT is the most robust over an imperfect or public network, RTMP is the simplest for a single feed, and UDP suits a clean local LAN.
Keep the external encoder’s keyframe interval short and steady so Medusa can segment the output cleanly — see Packaging and caching.

Related


Was this answer helpful?

« Back